Starbie

anshvirmani31-bit·Starbie

Starbie PCB layout, top view — open source ESP32 board by anshvirmani31-bit

About the Starbie PCB

Starbie is an open source ESP32 PCB design by anshvirmani31-bit, published on GitHub. It is a 2-layer board measuring 100 × 94.2 mm, with 8 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 3 switches, 2 ICs, 2 connectors and 1 resistor.

It belongs with the sensors designs in this gallery.

From the project

Hack Club Half Life week one pcb project design

Starbie is a tiny motion-controlled digital pet: basically a desktop Tamagotchi with minimal gameplay buttons. Instead of pressing controls, you interact with it by physically moving the board.

Starbie is designed to sit on your desk or stay in your hand. It reacts to how you handle (tilting it, moving it, shaking it, etc.)

This project was for my week one Half-Life. It was the starter project given to us. I added my own touch to it by adding an on/off button. I thought that this could be useful since if you're connecting starbie to a battery back on the go, you may not want it to be…

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

8 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
3
SW_Push
SW1, SW2, SW3
1
10k
R1

Starbie design files

The KiCad project lives in the anshvirmani31-bit/Starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 100 × 94.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

8 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the anshvirmani31-bit/Starbie repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with anshvirmani31-bit. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards