Architon cli
badimirzai·architon-cli·examples/custom-contracts/exports/custom_contracts.net

About the Architon cli PCB
Architon cli is an open source ESP32 PCB design by badimirzai, published on GitHub under the AGPL-3.0 license. It is a board, with 2 components from 2 distinct parts.
Its main chip is the ESP32-C3-WROOM-02, from the ESP32 family. Other key parts include the TB6612FNG.
It belongs with the robotics & motion designs in this gallery.
From the project
Deterministic hardware verification engine that fails CI when connected components violate electrical or interface contracts.
Fail fast on hardware integration mistakes before you build the board.
Architon is deterministic hardware architecture verification for robotics and embedded systems. It runs before PCB fabrication and firmware bring-up to catch electrical compatibility, power, logic-level, and integration failures early.
Architon detects electrical contract violations directly from KiCad projects before bring-up. Run Architon on a real hardware design and detect an integration failure:
Main components on the Architon cli
Architon cli bill of materials (BOM)
2 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-C3-WROOM-02 IMU_A | U1 | |
| 1 | TB6612FNG IMU_B | U2 |
Architon cli design files
The KiCad project lives in the badimirzai/architon-cli repository on GitHub; these links point at the commit this page was built from.
Architon cli: common questions
What microcontroller does the Architon cli use?
The Architon cli is built around the ESP32-C3-WROOM-02, from the ESP32 family.
How many components are on the Architon cli?
2 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Architon cli design files?
From the badimirzai/architon-cli repository on GitHub, which has a netlist and the BOM; the links under Design files point to each one.
Can I use the Architon cli design in my own project?
Yes, under the terms of its AGPL-3.0 license, which badimirzai chose for the repository.
Can I test firmware for the Architon cli without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k