Edid nuzzler

boldx·edid-nuzzler·hw/edid_nuzzler.kicad_pcb

Edid nuzzler PCB layout, top view — open source RISC-V board by boldx

About the Edid nuzzler PCB

Edid nuzzler is an open source RISC-V PCB design by boldx, published on GitHub. It is a 4-layer board measuring 49 × 32 mm, with 32 components from 15 distinct parts.

Its main chip is the CH32V003AXMX, from the RISC-V family. Other key parts include the 74LVC1G3157 and CH340N. By type, the board carries 12 resistors, 7 capacitors, 5 ICs, 4 connectors, 2 diodes and 1 transistor.

Main components on the Edid nuzzler

Edid nuzzler bill of materials (BOM)

32 components, 15 distinct parts — part numbers from the project's BOM.

QtyPartRefs
3
74LVC1G3157
U1, U2, U5
1
CH340N
U3
1
CH32V003AXMX
CH32V003AxMx
U4
1
BSS84AK
Q1
2
HDMI_A
J1, J2
1
CONN_02X03_COUNTER_CLOCKWISE
Conn_02x03_Counter_Clockwise
J3
1
USB_C_RECEPTACLE_USB2.0_16P
USB_C_Receptacle_USB2.0_16P
J4
1
SW_Push
SW1
1
LED_Small
D1
1
BAT54GW
D2
6
1u
C1, C2, C3, C4, C5, C7
1
0.1U
0.1u
C8
5
1K5
1k5
R1, R2, R3, R12, R13
5
5K1
5k1
R4, R5, R8, R9, R10
2
47K
47k
R6, R7

Edid nuzzler design files

The KiCad project lives in the boldx/edid-nuzzler repository on GitHub; these links point at the commit this page was built from.

Edid nuzzler: common questions

What microcontroller does the Edid nuzzler use?

The Edid nuzzler is built around the CH32V003AXMX, from the RISC-V family.

How big is the Edid nuzzler PCB?

The Edid nuzzler measures 49 × 32 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Edid nuzzler?

32 components, from 15 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Edid nuzzler design files?

From the boldx/edid-nuzzler repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Edid nuzzler design in my own project?

The repository has no license, so all rights stay with boldx. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Edid nuzzler without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RISC-V firmware against it before you order a PCB.

More boards in edid-nuzzler

Similar boards