Air poll

DeeptamBhar·air_poll·pcb/air_poll.kicad_pcb

Air poll PCB layout, top view — open source ESP32 board by DeeptamBhar

About the Air poll PCB

Air poll is an open source ESP32 PCB design by DeeptamBhar, published on GitHub under the MIT license. It is a 2-layer board measuring 22 × 38 mm, with 12 components from 9 distinct parts.

Its main chip is the MQ-X, from the ESP32 family. Other key parts include the LM393. By type, the board carries 4 resistors, 2 ICs, 2 capacitors, 1 relay and 1 diode.

Main components on the Air poll

Air poll bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
MQ-X
U1
1
LM393
U2
2
HOLE_3.2mm
H1, H2
1
HEADER_MALE_4X1
K1
1
purple
D1
2
0.1uF
C1, C2
2
10k
R1, R3
1
TC33X-2-103E
R2
1
2k2
R4

Air poll design files

The KiCad project lives in the DeeptamBhar/air_poll repository on GitHub; these links point at the commit this page was built from.

Air poll: common questions

What microcontroller does the Air poll use?

The Air poll is built around the MQ-X, from the ESP32 family.

How big is the Air poll PCB?

The Air poll measures 22 × 38 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Air poll?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Air poll design files?

From the DeeptamBhar/air_poll repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Air poll design in my own project?

Yes, under the terms of its MIT license, which DeeptamBhar chose for the repository.

Can I test firmware for the Air poll without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards