HWSW1
Deliciozy·HWSW1·schematics/device.kicad_sch

About the HWSW1 PCB
HWSW1 is an open source ESP32 PCB design by Deliciozy, published on GitHub. It is a board, with 4 components from 4 distinct parts.
Its main chip is the ESP32-C3-WROOM-02, from the ESP32 family. Other key parts include the ULN2003. By type, the board carries 2 ICs, 1 diode and 1 resistor.
It belongs with the robotics & motion, iot & wireless and wearables designs in this gallery.
From the project
A wearable bio-sensing system that tracks changes in heart rate over time and translates them into a slow, physical visualization. Instead of showing exact BPM numbers, it computes a simplified physiological change score and represents it using a motor-driven dial + LED.
A wearable bio-sensing system that tracks changes in heart rate over time and translates them into a slow, physical visualization. Instead of showing exact BPM numbers, it computes a simplified physiological change score and represents it using a motor-driven dial + LED.
General sketch (highlight physical features):
Main components on the HWSW1
HWSW1 bill of materials (BOM)
4 components, 4 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-C3-WROOM-02 | ESP32-C3-WROOM-02 | U2 |
| 1 | ULN2003 | U3 | |
| 1 | LED | D1 | |
| 1 | 330R R | R1 |
HWSW1 design files
The KiCad project lives in the Deliciozy/HWSW1 repository on GitHub; these links point at the commit this page was built from.
- Schematicschematics/device.kicad_sch
- BOMBOM.csv
HWSW1: common questions
What microcontroller does the HWSW1 use?
The HWSW1 is built around the ESP32-C3-WROOM-02, from the ESP32 family.
How many components are on the HWSW1?
4 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the HWSW1 design files?
From the Deliciozy/HWSW1 repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.
Can I use the HWSW1 design in my own project?
The repository has no license, so all rights stay with Deliciozy. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the HWSW1 without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8k