Wiimote ir sensor

eatnooM·pixart-sensor-adapter·socketed/wiimote-ir-sensor.kicad_pcb

Wiimote ir sensor PCB layout, top view — open source board by eatnooM

About the Wiimote ir sensor PCB

Wiimote ir sensor is an open source PCB design by eatnooM, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 13.5 × 16.3 mm, with 10 components from 8 distinct parts.

Other key parts include the AP2112-3.3V. By type, the board carries 3 capacitors, 3 resistors, 2 ICs, 1 crystal and 1 connector.

It belongs with the sensors designs in this gallery.

From the project

Board to allow interfacing with a Wiimote camera over I2C for light guns

Allows interfacing with a Wiimote camera over I2C for GUN4IR.

Variants are present to allow use of the module either socketed as you'd find it on the Wiimote, or unsocketed for more compact installs.

I've only clocked a few hours actually using these, so run this off at your own risk.

The inline board should be ordered in 0.8mm thickness, otherwise you won't be able to solder to the pads on the camera! If ordering from OSHPark, I'd recommend the panelised version as they tend to put panel tabs on the edge connectors which can make for annoying cleanup before the boards are usable.

Wiimote ir sensor, from the project README
From the project README

Main components on the Wiimote ir sensor

Wiimote ir sensor bill of materials (BOM)

10 components, 8 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
~
U1
1
AP2112-3.3V
U2
1
SG3225CAN 24.0000M-TJGA3
X1
1
Conn_01x04_Pin
J1
1
0.1UF
0.1uF
C1
2
1UF
1uF
C2, C3
2
2.7K
R1, R2
1
33K
R3

Wiimote ir sensor design files

The KiCad project lives in the eatnooM/pixart-sensor-adapter repository on GitHub; these links point at the commit this page was built from.

Wiimote ir sensor: common questions

How big is the Wiimote ir sensor PCB?

The Wiimote ir sensor measures 13.5 × 16.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Wiimote ir sensor?

10 components, from 8 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Wiimote ir sensor design files?

From the eatnooM/pixart-sensor-adapter repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Wiimote ir sensor design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which eatnooM chose for the repository.

More boards in pixart-sensor-adapter

Similar boards