My-Starbie

ElDragonMC·My-Starbie·PCB KiCad Files/StarbiePCB.kicad_pcb

My-Starbie PCB layout, top view — open source ESP32 board by ElDragonMC

About the My-Starbie PCB

My-Starbie is an open source ESP32 PCB design by ElDragonMC, published on GitHub. It is a 2-layer board measuring 123 × 116 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

From the project

this is my version of the hack club starbie

I liked and i wanted to make this project becouse it implies a PCB (i like designing them, sometimes i design ramdom things to spend some time) but i don't know how to code on arduino so i did not costumize the code a lot, only the main character). I loved to design and make this PCB, i've never thinked i could make a "tamagotchi" but i loved this.

I designed the PCB with KiCad (the only PCB design software i know to use) following the guide from HackClub. The code i've grabbed it from the guide and i changed the main character to a yoda. I waned to design a case for this project but i did…

My-Starbie, from the project README
From the project README

Main components on the My-Starbie

My-Starbie bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
R
R1

My-Starbie design files

The KiCad project lives in the ElDragonMC/My-Starbie repository on GitHub; these links point at the commit this page was built from.

My-Starbie: common questions

What microcontroller does the My-Starbie use?

The My-Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the My-Starbie PCB?

The My-Starbie measures 123 × 116 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the My-Starbie?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the My-Starbie design files?

From the ElDragonMC/My-Starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the My-Starbie design in my own project?

The repository has no license, so all rights stay with ElDragonMC. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the My-Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards