Receiver protection v1

erikarn·radio-pcbs·receiver-protection-v1/receiver-protection-v1.kicad_pcb

Receiver protection v1 PCB layout, top view — open source board by erikarn

About the Receiver protection v1 PCB

Receiver protection v1 is an open source PCB design by erikarn, published on GitHub. It is a 2-layer board measuring 61 × 29.2 mm, with 13 components from 11 distinct parts.

By type, the board carries 5 diodes, 3 connectors, 2 resistors, 1 transistor, 1 relay and 1 capacitor.

It belongs with the rf & radio designs in this gallery.

From the project

playpen for radio pcbs

This is a super simple project to provide some level of protection of an SDR receiver.

It adds surge protection, signal level clamping diodes and defaults to shorting the receiver input when the power isn't applied.

I designed this to be able to leave in front of SDRs which may be located near transmit antennas. No, this won't protect your SDR against a directly connected transmitter - ie, it's not a TX/RX switch! - but it provides similar levels of protection as your solid state HF/VHF/UHF transceiver may have.

Receiver protection v1 bill of materials (BOM)

13 components, 11 distinct parts.

QtyPartRefs
1
2N3904
Q1
1
INPUT
J1
1
OUTPUT
J2
1
POWER/CTRL
J3
1
DS1E-M-DC12V
K1
2
Surge
D1, D5
2
1N4148
D2, D3
1
1N4001
D4
1
0.1uF
C1
1
2.2K
R1
1
10K
R2

Receiver protection v1 design files

The KiCad project lives in the erikarn/radio-pcbs repository on GitHub; these links point at the commit this page was built from.

Receiver protection v1: common questions

How big is the Receiver protection v1 PCB?

The Receiver protection v1 measures 61 × 29.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Receiver protection v1?

13 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Receiver protection v1 design files?

From the erikarn/radio-pcbs repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Receiver protection v1 design in my own project?

The repository has no license, so all rights stay with erikarn. Use it as a reference, and ask the author before reusing the design.

More boards in radio-pcbs

Similar boards