Half-Life-Week-1-Starbie

finleyjamesrogers-cmd·Half-Life-Week-1-Starbie·PCB/KiCad PCB.kicad_pcb

Half-Life-Week-1-Starbie PCB layout, top view — open source ESP32 board by finleyjamesrogers-cmd

About the Half-Life-Week-1-Starbie PCB

Half-Life-Week-1-Starbie is an open source ESP32 PCB design by finleyjamesrogers-cmd, published on GitHub. It is a 2-layer board measuring 68.3 × 68.3 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors designs in this gallery.

From the project

My version of the Half Life week 1 challenge Starbie!

The board includes a microcontroller, display, gyro/motion sensor and Temperature/Humidity Sensor all in a compact PCB design.

It is powered by USB and made for beginner-friendly through-hole soldering for the add on components

- KiCad was used for the PCB schematics, design and routing.

- Piskel was used for creating the turtle sprite.

Half-Life-Week-1-Starbie, from the project README
From the project README

Main components on the Half-Life-Week-1-Starbie

Half-Life-Week-1-Starbie bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
R
R1

Half-Life-Week-1-Starbie design files

The KiCad project lives in the finleyjamesrogers-cmd/Half-Life-Week-1-Starbie repository on GitHub; these links point at the commit this page was built from.

Half-Life-Week-1-Starbie: common questions

What microcontroller does the Half-Life-Week-1-Starbie use?

The Half-Life-Week-1-Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Half-Life-Week-1-Starbie PCB?

The Half-Life-Week-1-Starbie measures 68.3 × 68.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Half-Life-Week-1-Starbie?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Half-Life-Week-1-Starbie design files?

From the finleyjamesrogers-cmd/Half-Life-Week-1-Starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Half-Life-Week-1-Starbie design in my own project?

The repository has no license, so all rights stay with finleyjamesrogers-cmd. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Half-Life-Week-1-Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards