Starbie

gvlf·starbie·starbie/starbie.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by gvlf

About the Starbie PCB

Starbie is an open source ESP32 PCB design by gvlf, published on GitHub. It is a 2-layer board measuring 92.3 × 90.2 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

From the project

Half-Life Hack Club Week 1: A Tamagotchi-like machine self made!

The whole process of making this piece of hardware is written in detail in JOURNAL.MD. It took me about 2hrs for the initial setup and making the schematic, the other 4 hours went to the PCB.

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push_45deg
SW1, SW2
1
10K
R1

Starbie design files

The KiCad project lives in the gvlf/starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 92.3 × 90.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the gvlf/starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with gvlf. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards