Kestrel gps

HeyPCB·kestrel-gps·kicad/kestrel_gps.kicad_pcb

Kestrel gps PCB layout, top view — open source board by HeyPCB

About the Kestrel gps PCB

Kestrel gps is an open source PCB design by HeyPCB, published on GitHub under the CERN-OHL-S-2.0 license. It is a 4-layer board measuring 28 × 28 mm, with 13 components from 9 distinct parts.

Other key parts include the MAX-M10S-00B, LIS3MDLTR and XC6206P332MR-G. By type, the board carries 8 capacitors, 3 ICs, 1 connector and 1 test point.

It belongs with the rf & radio and robotics & motion designs in this gallery.

From the project

Kestrel GPS: u-blox MAX-M10S under a 25 mm ceramic patch with an LIS3MDL compass, for Betaflight, INAV and ArduPilot. 28 x 28 mm 4-layer KiCad 10 board, DRC clean, with gerbers, BOM, CPL and STEP.

A u-blox MAX-M10S under a 25 mm ceramic patch, with an LIS3MDL compass, on a 28 x 28 mm board that plugs 1:1 into the Kestrel H7.

The Kestrel GPS is the navigation module of Kestrel. Its top face is unbroken ground for the patch antenna, whose feed pin passes through a plated hole to one 2.5 mm track to the receiver; every part is on the bottom face. Betaflight, INAV and ArduPilot all have drivers for both chips.

Kestrel gps, from the project README
From the project README

Main components on the Kestrel gps

Kestrel gps bill of materials (BOM)

13 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
MAX-M10S-00B
MAX-M10S
U1
1
LIS3MDLTR
LIS3MDL
U2
1
XC6206P332MR-G
XC6206P332MR
U3
1
SM06B-SRSS-TB(LF)(SN)
GPS
J1
1
ANT
TP1
1
CL21A106KAYNNNE
10uF
C1
4
CL05B104KO5NNNC
100nF
C2, C3, C4, C5
1
CL05A105KA5NQNC
1uF
C6
2
CL10A105KB8NNNC
1uF
C7, C8

Kestrel gps design files

The KiCad project lives in the HeyPCB/kestrel-gps repository on GitHub; these links point at the commit this page was built from.

Kestrel gps: common questions

How big is the Kestrel gps PCB?

The Kestrel gps measures 28 × 28 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Kestrel gps?

13 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Kestrel gps design files?

From the HeyPCB/kestrel-gps repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Kestrel gps design in my own project?

Yes, under the terms of its CERN-OHL-S-2.0 license, which HeyPCB chose for the repository.

Similar boards