Haptic

JavaScythe·haptic·pcb/haptic.kicad_pcb

Haptic PCB layout, top view — open source Microchip SAM board by JavaScythe

About the Haptic PCB

Haptic is an open source Microchip SAM PCB design by JavaScythe, published on GitHub. It is a 2-layer board measuring 40.1 × 27.4 mm, with 53 components from 22 distinct parts.

Its main chip is the ATSAMD11D14A-M, from the Microchip SAM family. Other key parts include the USBLC6-2P6 and MIC5504-3.3YM5. By type, the board carries 20 resistors, 9 diodes, 8 transistors, 8 connectors, 4 capacitors and 3 ICs.

From the project

8 channel easy haptic controller

Why? To take advantage of the low pricing of these motors, while driving them in a cost efficient but low latency and sufficiently powered manner.

Haptic, from the project README
From the project README

Main components on the Haptic

Haptic bill of materials (BOM)

53 components, 22 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATSAMD11D14A-M
U1
1
USBLC6-2P6
U2
1
MIC5504-3.3YM5
U3
8
AO3400A
Q1, Q2, Q3, Q4, Q5, Q6, Q7, Q8
1
SWD
J1
1
Vin
J2
1
Common High
J3
1
Extra
J4
4
Motor
J5, J6, J7, J8
1
U-M-M5DD-W-1
USB1
8
D
D1, D3, D4, D5, D6, D7, D8, D9
1
0603
D2
2
10UF
10uF
C1, C2
1
100NF
100nF
C3
1
1NF
1nF
C4
2
C107701
R1, R2
1
C98220
R3
1
C105588
R4
1
C22548
R5
7
100
R6, R8, R10, R12, R13, R14, R15
Show 2 more
QtyPartRefs
7
10K
10k
R7, R9, R11, R16, R17, R18, R19
1
1M
R20

Haptic design files

The KiCad project lives in the JavaScythe/haptic repository on GitHub; these links point at the commit this page was built from.

Haptic: common questions

What microcontroller does the Haptic use?

The Haptic is built around the ATSAMD11D14A-M, from the Microchip SAM family.

How big is the Haptic PCB?

The Haptic measures 40.1 × 27.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Haptic?

53 components, from 22 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Haptic design files?

From the JavaScythe/haptic repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Haptic design in my own project?

The repository has no license, so all rights stay with JavaScythe. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Haptic without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Microchip SAM firmware against it before you order a PCB.

Similar boards