PumpMonitor

jgOhYeah·Farm-PJON-LoRa-network·PumpMonitor/PumpMonitorVeroboardLayout/PumpMonitor.kicad_pcb

PumpMonitor PCB layout, top view — open source board by jgOhYeah

About the PumpMonitor PCB

PumpMonitor is an open source PCB design by jgOhYeah, published on GitHub under the MIT license. It is a 2-layer board measuring 119.4 × 55.9 mm, with 30 components from 24 distinct parts.

Other key parts include the LM317_TO-220, 24LC16 and PICAXE-18M2. By type, the board carries 12 resistors, 5 capacitors, 4 connectors, 3 ICs, 3 diodes and 2 transistors.

It belongs with the rf & radio, power & battery and displays & leds designs in this gallery.

From the project

Code relating to a small LoRa network for remote monitoring and control

This branch of the PyLora library is required to talk to the radio module as it has been adapted for python 3.

Battery voltage monitor before the mosfet was added for controlling the fence and an external antenna to improve range.

The shed and setup of the battery monitor.

The monitor currently operates by timing how many half seconds the pump is on in a half hour block. At the end of each block, the monitor saves the time to a circular buffer stored in an EEPROM chip, calculates the average on time for all values in the chip and transmits the time on in the last half hour as well as the…

PumpMonitor, from the project README
From the project README

Main components on the PumpMonitor

PumpMonitor bill of materials (BOM)

30 components, 24 distinct parts.

QtyPartRefs
1
LM317_TO-220
U1
1
24LC16
U2
1
PICAXE-18M2
U3
2
BC548
Q1, Q2
1
Power & Current Sense
J1
1
Programming
J2
1
Ra01_Breakout_Module
J3
1
AHT20 Temperature Sensor
J4
1
SW_Push
SW1
1
Power
D1
1
Alarm
D2
1
Pump On
D3
2
100u
C1, C3
1
10u
C2
1
33u
C4
1
100n
C5
1
270
R1
1
470
R2
1
220k
R3
3
10k
R4, R7, R9
Show 4 more
QtyPartRefs
2
2.2k
R5, R8
2
150
R6, R12
1
22k
R10
1
180
R11

PumpMonitor design files

The KiCad project lives in the jgOhYeah/Farm-PJON-LoRa-network repository on GitHub; these links point at the commit this page was built from.

PumpMonitor: common questions

How big is the PumpMonitor PCB?

The PumpMonitor measures 119.4 × 55.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the PumpMonitor?

30 components, from 24 distinct parts. The full bill of materials is listed on this page.

Where can I download the PumpMonitor design files?

From the jgOhYeah/Farm-PJON-LoRa-network repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the PumpMonitor design in my own project?

Yes, under the terms of its MIT license, which jgOhYeah chose for the repository.

More boards in Farm-PJON-LoRa-network

Similar boards