First hack club project

Neon-queen·first-hack-club-project

First hack club project PCB layout, top view — open source ESP32 board by Neon-queen

About the First hack club project PCB

First hack club project is an open source ESP32 PCB design by Neon-queen, published on GitHub. It is a 2-layer board measuring 145.5 × 117.5 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

From the project

This is my first Hack Club hardware project made with KiCad. It’s a star-shaped PCB with two push buttons and connectors. The board is designed for simple input control and learning PCB design.

First hack club project, from the project README
From the project README

Main components on the First hack club project

First hack club project bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
CONN_01X04_PIN
Conn_01x04_Pin
J1
1
CONN_01X08_PIN
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10K
R1

First hack club project design files

The KiCad project lives in the Neon-queen/first-hack-club-project repository on GitHub; these links point at the commit this page was built from.

First hack club project: common questions

What microcontroller does the First hack club project use?

The First hack club project is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the First hack club project PCB?

The First hack club project measures 145.5 × 117.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the First hack club project?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the First hack club project design files?

From the Neon-queen/first-hack-club-project repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the First hack club project design in my own project?

The repository has no license, so all rights stay with Neon-queen. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the First hack club project without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards