HardLabs

Touch sensor

Open-Air-Foundation·pcb-go·PCB/touch-pad/touch_pad.kicad_pcb

Touch sensor PCB layout, top view — open source board by Open-Air-Foundation

About the Touch sensor PCB

Touch sensor is an open source PCB design by Open-Air-Foundation, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 60.6 × 50.7 mm, with 3 components from 1 distinct parts.

It belongs with the sensors, power & battery and rf & radio designs in this gallery.

From the project

AirGradient GO is a handheld air quality monitor. It measures particulate matter (Sensirion SPS30), CO₂ (Senseair S12), VOC/NOx (SGP41), temperature and humidity (SHT4x), and barometric pressure (DPS368), with an accelerometer (LIS2DH12) for motion detection and a GPS receiver (T

AirGradient GO is a handheld air quality monitor. It measures particulate matter (Sensirion SPS30), CO₂ (Senseair S12), VOC/NOx (SGP41), temperature and humidity (SHT4x), and barometric pressure (DPS368), with an accelerometer (LIS2DH12) for motion detection and a GPS receiver (TAU1113) for location. Readings are shown on a 2.13″ black-and-white e-paper display with RGB LED indicators and capacitive touch controls. The device runs on a 505060 Li-Po pouch cell charged over USB-C.

Touch sensor bill of materials (BOM)

3 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
3
~
T1, T2, T3

Touch sensor design files

The KiCad project lives in the Open-Air-Foundation/pcb-go repository on GitHub; these links point at the commit this page was built from.

Touch sensor: common questions

How big is the Touch sensor PCB?

The Touch sensor measures 60.6 × 50.7 mm, has 2 copper layers and is 1 mm thick.

How many components are on the Touch sensor?

3 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Touch sensor design files?

From the Open-Air-Foundation/pcb-go repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Touch sensor design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which Open-Air-Foundation chose for the repository.

More boards in pcb-go

Similar boards