Front panel
PE1RGU·hf-antenna-switch·hardware/shack-interface/endplates/front-panel.kicad_pcb
About the Front panel PCB
Front panel is an open source PCB design by PE1RGU, published on GitHub under the CERN-OHL-S-2.0 license. It is a 2-layer board measuring 165 × 51.1 mm, with 4 components from 1 distinct parts.
It belongs with the rf & radio designs in this gallery.
From the project
Remote HF antenna switch: 3 radios x 4 antennas (path to 8), outdoor relay unit with a hardware safety chain, controlled over Cat6 from a shack interface. KiCad 10, open hardware, designed together with an AI.
A remote antenna switch for an HF amateur radio station: 3 radios, 4 antennas, one Cat6 cable, and the safety rules in hardware. Designed by a radio amateur together with an AI assistant, and documented decision by decision.
The relay unit sits outdoors, close to the antennas, in a milled aluminium case. A small interface box in the shack controls it over one Cat6 cable. A computer sends the commands over USB. If anything goes wrong (a cable break, a box fault, a press on the KILL switch), every radio is inhibited and every relay is released, without help from the firmware.

Front panel bill of materials (BOM)
4 components, 1 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 4 | — | SP1, SP2, SP3, SP4 |
Front panel design files
The KiCad project lives in the PE1RGU/hf-antenna-switch repository on GitHub; these links point at the commit this page was built from.
Front panel: common questions
How big is the Front panel PCB?
The Front panel measures 165 × 51.1 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Front panel?
4 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Front panel design files?
From the PE1RGU/hf-antenna-switch repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.
Can I use the Front panel design in my own project?
Yes, under the terms of its CERN-OHL-S-2.0 license, which PE1RGU chose for the repository.
More boards in hf-antenna-switch
Similar boards
Hat
pa3gsb
65 × 56 mm81 parts2LNo license675Radioberry juice
pa3gsb
65 × 56 mm87 parts2LNo license675Radioberry preamp
pa3gsb
65 × 56 mm137 parts2LNo license675Goodwatch20
travisgoodspeed
25.6 × 27.6 mm20 parts2LNo license568GoodPocketWatch
travisgoodspeed
75.2 × 101.2 mm56 parts2LNo license568Goodwatch31
travisgoodspeed
25.6 × 27.6 mm23 parts2LNo license568