Pressure Sensor Board
RatKinng·FireLord·pcb-and-schematics/Pressure_Sensor/Pressure_Sensor_Board/Pressure_Sensor_Board.kicad_pcb
About the Pressure Sensor Board
Pressure Sensor Board is an open source PCB design by RatKinng, published on GitHub. It is a 2-layer board measuring 11.4 × 2 mm, with 3 components from 2 distinct parts.
Other key parts include the MPL115A1. By type, the board carries 2 connectors and 1 IC.
It belongs with the sensors, rf & radio and power & battery designs in this gallery.
From the project
The KiCad project in this directory defines the sensor carrier board used by FireLord. It is suitable for small fabrication runs and straightforward to adapt for alternate sensors or power stages.
The KiCad project in this directory defines the sensor carrier board used by FireLord. It is suitable for small fabrication runs and straightforward to adapt for alternate sensors or power stages.
Open the .kicadpro file in KiCad 7+. If footprints appear missing, point KiCad to the bundled PressureSensor.pretty` library.
- Seeeduino XIAO header exposing I²C, UART, analog, and power rails. - JST or locking connectors for CO, smoke, VOC, and other sensor daughterboards. - SCD40 and MPL115A2 wired on a shared I²C bus with 400 kHz pull-ups. - Supercapacitor pads with balancing resistors and…
Main components on the Pressure Sensor Board
Pressure Sensor Board bill of materials (BOM)
3 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | MPL115A1 | NXP_LGA-8_3x5mm_P1.25mm_H1.2mm | U1 |
| 2 | Conn_01x04_Pin | PinHeader_1x04_P1.27mm_Vertical | J3, J4 |
Pressure Sensor Board design files
The KiCad project lives in the RatKinng/FireLord repository on GitHub; these links point at the commit this page was built from.
Pressure Sensor Board: common questions
How big is the Pressure Sensor Board?
The Pressure Sensor Board measures 11.4 × 2 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Pressure Sensor Board?
3 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the Pressure Sensor Board design files?
From the RatKinng/FireLord repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Pressure Sensor Board design in my own project?
The repository has no license, so all rights stay with RatKinng. Use it as a reference, and ask the author before reusing the design.
More boards in FireLord
Similar boards
Sensor smd
scottbez1
40 × 20 mm5 parts2LApache-2.04.2kSensors
StuckAtPrototype
15.2 × 9 mm14 parts4LApache-2.03.8kEinkPDA screen
TalismanDesign
95 × 54 mm27 parts2LApache-2.02.0kStack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7kDisplay Carrier
AxxAxx
35.6 × 58.2 mm5 parts2LGPL-3.01.7kMicrophone
Mentra-Community
5.5 × 6.1 mm6 parts2LMIT1.2k