Controller
RayaneGuebre·Quadruped-Robot·PCB/Controller.kicad_pcb
About the Controller PCB
Controller is an open source ESP32 PCB design by RayaneGuebre, published on GitHub. It is a 2-layer board measuring 172 × 100.2 mm, with 7 components from 3 distinct parts.
Its main chip is the DFR0654, from the ESP32 family. Other key parts include the COM-09032. By type, the board carries 4 switches and 3 ICs.
It belongs with the robotics & motion designs in this gallery.
From the project
My first robot
the motherboard connects each pin of the esp32 to a screw terminal for future upgrades and changes
Main components on the Controller
Controller bill of materials (BOM)
7 components, 3 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 2 | COM-09032 | XDCR_COM-09032 | U1, U3 |
| 1 | DFR0654 | MODULE_DFR0654 | U2 |
| 4 | FSM11JH | FSM11JH | S1, S2, S3, S4 |
Controller design files
The KiCad project lives in the RayaneGuebre/Quadruped-Robot repository on GitHub; these links point at the commit this page was built from.
- LayoutPCB/Controller.kicad_pcb
- SchematicPCB/Controller.kicad_sch
- BOMBOM quadruped robot.csv
Controller: common questions
What microcontroller does the Controller use?
The Controller is built around the DFR0654, from the ESP32 family.
How big is the Controller PCB?
The Controller measures 172 × 100.2 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Controller?
7 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Controller design files?
From the RayaneGuebre/Quadruped-Robot repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Controller design in my own project?
The repository has no license, so all rights stay with RayaneGuebre. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the Controller without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
More boards in Quadruped-Robot
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k