Switcher

rickwargo·CATS·Blower Switch/Switcher.kicad_pcb

Switcher PCB layout, top view — open source ESP32 board by rickwargo

About the Switcher PCB

Switcher is an open source ESP32 PCB design by rickwargo, published on GitHub. It is a 2-layer board measuring 35 × 50 mm, with 18 components from 6 distinct parts.

Its main chip is the 3.3V Power, from the ESP32 family. Other key parts include the 34.81-7048. By type, the board carries 8 resistors, 5 ICs, 4 transistors and 1 connector.

From the project

An ESP32 system to add some spark into my '00 Z3M

Main components on the Switcher

34.81-70483.3V Power

Switcher bill of materials (BOM)

18 components, 6 distinct parts.

QtyPartRefs
4
34.81-7048
U1, U2, U3, U4
1
3.3V Power
U6
4
BC337
Q1, Q2, Q3, Q4
1
Conn_01x04_Socket
J1
4
100K
R1, R2, R3, R4
4
2K2
R5, R6, R7, R8

Switcher design files

The KiCad project lives in the rickwargo/CATS repository on GitHub; these links point at the commit this page was built from.

Switcher: common questions

What microcontroller does the Switcher use?

The Switcher is built around the 3.3V Power, from the ESP32 family.

How big is the Switcher PCB?

The Switcher measures 35 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Switcher?

18 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Switcher design files?

From the rickwargo/CATS repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Switcher design in my own project?

The repository has no license, so all rights stay with rickwargo. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Switcher without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in CATS

Similar boards