Starbie

rimzooi·starbie·finalfolder/finalbatstarbie.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by rimzooi

About the Starbie PCB

Starbie is an open source ESP32 PCB design by rimzooi, published on GitHub. It is a 2-layer board measuring 107 × 79.5 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

From the project

Half-Life week 1 PCB project Made using starbie beginners guide The project was started by using KiCad to place all the parts together, first by using the schematic editor to organize the parts

Half-Life week 1 PCB project Made using starbie beginners guide The project was started by using KiCad to place all the parts together, first by using the schematic editor to organize the parts

After having my plan laid out I used the PCB editor to build a cutout shape and decide how the components will fit into said shape

Then I ran into an issue with the edge cuts so I had to trace the entire thing over with a single polygon drawing tool. After this I downloaded everything I needed to code and uploaded the code from the starbie guide. I then made a few edits to the code to make it my own.

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x08_Pin
J1
1
Conn_01x04_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Starbie design files

The KiCad project lives in the rimzooi/starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 107 × 79.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the rimzooi/starbie repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with rimzooi. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards