Half lIfe hack-Designs

Salamix8680·Half-lIfe-hack-Designs·PCB/halfLife.kicad_pcb

Half lIfe hack-Designs PCB layout, top view — open source ESP32 board by Salamix8680

About the Half lIfe hack-Designs PCB

Half lIfe hack-Designs is an open source ESP32 PCB design by Salamix8680, published on GitHub. It is a 2-layer board measuring 100.1 × 49.5 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors designs in this gallery.

From the project

This contains logs and usable codes for all my build

A pocket-sized virtual pet on a custom PCB. A tiny pet lives on an OLED screen, reacts when you tilt or shake it, and senses the room's temperature and humidity.

Half lIfe hack-Designs, from the project README
From the project README

Main components on the Half lIfe hack-Designs

Half lIfe hack-Designs bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
CONN_01X04_PIN
Conn_01x04_Pin
J1
1
CONN_01X08
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10K
R1

Half lIfe hack-Designs design files

The KiCad project lives in the Salamix8680/Half-lIfe-hack-Designs repository on GitHub; these links point at the commit this page was built from.

Half lIfe hack-Designs: common questions

What microcontroller does the Half lIfe hack-Designs use?

The Half lIfe hack-Designs is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Half lIfe hack-Designs PCB?

The Half lIfe hack-Designs measures 100.1 × 49.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Half lIfe hack-Designs?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Half lIfe hack-Designs design files?

From the Salamix8680/Half-lIfe-hack-Designs repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Half lIfe hack-Designs design in my own project?

The repository has no license, so all rights stay with Salamix8680. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Half lIfe hack-Designs without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards