HardLabs

Iowa rover kiosk rfid

scimusmn·iowa-rover·kiosk/electronics/iowa-rover-kiosk-rfid/iowa-rover-kiosk-rfid.kicad_pcb

Iowa rover kiosk rfid PCB layout, top view — open source AVR/Arduino board by scimusmn

About the Iowa rover kiosk rfid PCB

Iowa rover kiosk rfid is an open source AVR/Arduino PCB design by scimusmn, published on GitHub. It is a 2-layer board measuring 38.7 × 47 mm, with 9 components from 6 distinct parts.

Its main chip is the ATtiny84-20P, from the AVR/Arduino family. Other key parts include the ID12-LA. By type, the board carries 3 jumpers, 2 ICs, 2 connectors, 1 diode and 1 resistor.

From the project

Iowa Science Rover - Electronics ================================

Iowa Science Rover - Electronics ================================

Due to the myriad inputs and outputs that need to be managed, the electronics of the kiosk have been split into a constellation of connected boards rather than using a single monolithic board. The scheme of connections is as follows:

Arduino Mega: This is an ATmega2560-based microcontroller, used as the central processor for the kiosk. Mega Adapter: This provides a convenient 40-pin ribbon cable connection between the Arduino Mega and the main board. It carries power from the main board to the Arduino. Main Board: The heart…

Iowa rover kiosk rfid, from the project README
From the project README

Main components on the Iowa rover kiosk rfid

ID12-LAATtiny84-20P

Iowa rover kiosk rfid bill of materials (BOM)

9 components, 6 distinct parts.

QtyPartRefs
1
ID12-LA
U1
1
ATtiny84-20P
U2
2
Conn_01x04
J1, J2
3
Jumper_2_Bridged
JP1, JP2, JP3
1
LED
D1
1
R
R1

Iowa rover kiosk rfid design files

The KiCad project lives in the scimusmn/iowa-rover repository on GitHub; these links point at the commit this page was built from.

Iowa rover kiosk rfid: common questions

What microcontroller does the Iowa rover kiosk rfid use?

The Iowa rover kiosk rfid is built around the ATtiny84-20P, from the AVR/Arduino family.

How big is the Iowa rover kiosk rfid PCB?

The Iowa rover kiosk rfid measures 38.7 × 47 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Iowa rover kiosk rfid?

9 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Iowa rover kiosk rfid design files?

From the scimusmn/iowa-rover repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Iowa rover kiosk rfid design in my own project?

The repository has no license, so all rights stay with scimusmn. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Iowa rover kiosk rfid without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in iowa-rover

Similar boards