PCB for temperature sensor
About the PCB for temperature sensor
PCB for temperature sensor is an open source PCB design by Sergio5714, published on GitHub. It is a 2-layer board measuring 30.5 × 13.1 mm, with 5 components from 4 distinct parts.
By type, the board carries 2 resistors, 1 connector, 1 transformer and 1 capacitor.
It belongs with the sensors designs in this gallery.
From the project
Firmware for STM32 MCU of testbed data acquisition and control system
This repository contains embedded software and the PCBs for the experimental testbed.
The main function of the testbed: * Imitate heat exchange, thermoelectric and electric proceses in the wearable thermoelectric generator.
Testbed's subsystems enable: Low speed (>= 5 Hz) temperature measurements with an accuracy better than 0.15°K; Temperature difference stabilization (temperature swing = 1 mv) in a range of approximately 0 - 100 mV; * Real time data visialization.
PCB for temperature sensor bill of materials (BOM)
5 components, 4 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | — | CWF-4R | P1 |
| 1 | Si7051 | DFN_6 | T1 |
| 1 | 0.1 μF | C_0603_HandSoldering | C1 |
| 2 | 10k | R_0603_HandSoldering | R1, R2 |
PCB for temperature sensor design files
The KiCad project lives in the Sergio5714/experimental-teg-testbed-firmware repository on GitHub; these links point at the commit this page was built from.
PCB for temperature sensor: common questions
How big is the PCB for temperature sensor?
The PCB for temperature sensor measures 30.5 × 13.1 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the PCB for temperature sensor?
5 components, from 4 distinct parts. The full bill of materials is listed on this page.
Where can I download the PCB for temperature sensor design files?
From the Sergio5714/experimental-teg-testbed-firmware repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the PCB for temperature sensor design in my own project?
The repository has no license, so all rights stay with Sergio5714. Use it as a reference, and ask the author before reusing the design.
More boards in experimental-teg-testbed-firmware
Similar boards
Sensor smd
scottbez1
40 × 20 mm5 parts2LApache-2.04.2k
Sensors
StuckAtPrototype
15.2 × 9 mm14 parts4LApache-2.03.8k
Microphone
Mentra-Community
5.5 × 6.1 mm6 parts2LMIT1.2k
TemperaturePCB PANEL
stuartpittaway
116 × 75.5 mm178 parts2LCC-BY-NC-4.01.1k
Pots
shanteacontrols
390 × 93 mm75 parts2LApache-2.0956
USB
52 × 12.6 mm6 parts2LApache-2.0956