My-Starbie

siddhantverma04·My-Starbie

My-Starbie PCB layout, top view — open source ESP32 board by siddhantverma04

About the My-Starbie PCB

My-Starbie is an open source ESP32 PCB design by siddhantverma04, published on GitHub. It is a 2-layer board measuring 108.9 × 74.6 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 4 ICs, 2 switches and 1 resistor.

It belongs with the keyboards designs in this gallery.

From the project

My own Starbie made for Hackclub's Half Life.

My-Starbie, from the project README
From the project README

Main components on the My-Starbie

My-Starbie bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
~
U2
1
~
U3
1
DHT11
U4
2
SW_Push
SW1, SW2
1
10k
R1

My-Starbie design files

The KiCad project lives in the siddhantverma04/My-Starbie repository on GitHub; these links point at the commit this page was built from.

My-Starbie: common questions

What microcontroller does the My-Starbie use?

The My-Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the My-Starbie PCB?

The My-Starbie measures 108.9 × 74.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the My-Starbie?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the My-Starbie design files?

From the siddhantverma04/My-Starbie repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the My-Starbie design in my own project?

The repository has no license, so all rights stay with siddhantverma04. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the My-Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards