Radio

tdwgithub·dih-dah-blue·hardware/radio/radio.kicad_pcb

Radio PCB layout, top view — open source ESP32 board by tdwgithub

About the Radio PCB

Radio is an open source ESP32 PCB design by tdwgithub, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 50.8 × 50.8 mm, with 19 components from 13 distinct parts.

Its main chip is the XIAO-ESP32-C6, from the ESP32 family. Other key parts include the ASSR-1228-002E. By type, the board carries 5 resistors, 3 diodes, 3 capacitors, 2 ICs, 2 connectors and 2 switches.

It belongs with the iot & wireless, rf & radio and power & battery designs in this gallery.

From the project

ESP32C6 Wireless CW paddle project

A Bluetooth LE wireless link between a Morse code (CW) paddle and a radio.

Dih Dah Blue replaces the cable between your CW paddle and your radio with a pair of small battery-powered boards. The paddle-side board watches the paddle contacts and sends each transition over Bluetooth LE. The radio-side board drives a solid-state relay wired to the radio's key input. To your radio, it looks like the paddle is plugged straight in.

Radio, from the project README
From the project README

Main components on the Radio

XIAO-ESP32-C6ASSR-1228-002E

Radio bill of materials (BOM)

19 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C6
U1
1
ASSR-1228-002E
U2
1
Screw_Terminal_01x03
J1
1
Battery
J3
2
Conn_01x02_Pin
Batt1, EN1
2
SW_Push
SW1, SW2
1
LED
D1
2
P4KE15CA
D2, D3
2
100 nF
C1, C2
1
0.01uF
C3
2
180 ohm
R1, R2
1
1 k
R3
2
10 ohm
R4, R5

Radio design files

The KiCad project lives in the tdwgithub/dih-dah-blue repository on GitHub; these links point at the commit this page was built from.

Radio: common questions

What microcontroller does the Radio use?

The Radio is built around the XIAO-ESP32-C6, from the ESP32 family.

How big is the Radio PCB?

The Radio measures 50.8 × 50.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Radio?

19 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Radio design files?

From the tdwgithub/dih-dah-blue repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Radio design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which tdwgithub chose for the repository.

Can I test firmware for the Radio without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in dih-dah-blue

Similar boards