Test 3

TekBot-Robotics-Challenge·2025-Team-The_Winners-Docs·electonic/test3/KiCad/Test_3.kicad_pcb

Test 3 PCB layout, top view — open source AVR/Arduino board by TekBot-Robotics-Challenge

About the Test 3 PCB

Test 3 is an open source AVR/Arduino PCB design by TekBot-Robotics-Challenge, published on GitHub. It is a 2-layer board measuring 105.7 × 75.5 mm, with 71 components from 19 distinct parts.

Its main chip is the ATmega328-P, from the AVR/Arduino family. By type, the board carries 26 diodes, 23 resistors, 8 transistors, 6 capacitors, 5 connectors and 1 IC.

Main components on the Test 3

Test 3 bill of materials (BOM)

71 components, 19 distinct parts.

QtyPartRefs
1
ATmega328-P
U1
7
2N2219
Q1, Q2, Q3, Q4, Q5, Q7, Q8
1
NMOS
Q6
1
Crystal
Y1
1
Prog_connector
J1
1
Conn_01x05_Pin
J2
1
5V_power_Pins
J3
1
LED_pwm_connector
J4
1
Batt_connector
J5
1
SW_Push
SW1
26
LED
D1, D2, D3, D4, D5, D6, D7, D8 +18
1
100nF
C1
2
22pF
C2, C3
2
470µF
C4, C5
1
100n
C6
18
R
R1, R2, R4, R5, R6, R8, R9, R10 +10
1
220
R3
3
10k
R7, R16, R17
1
4.7k
R18

Test 3 design files

The KiCad project lives in the TekBot-Robotics-Challenge/2025-Team-The_Winners-Docs repository on GitHub; these links point at the commit this page was built from.

Test 3: common questions

What microcontroller does the Test 3 use?

The Test 3 is built around the ATmega328-P, from the AVR/Arduino family.

How big is the Test 3 PCB?

The Test 3 measures 105.7 × 75.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Test 3?

71 components, from 19 distinct parts. The full bill of materials is listed on this page.

Where can I download the Test 3 design files?

From the TekBot-Robotics-Challenge/2025-Team-The_Winners-Docs repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Test 3 design in my own project?

The repository has no license, so all rights stay with TekBot-Robotics-Challenge. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Test 3 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in 2025-Team-The_Winners-Docs

Similar boards