Kimera
TheClanLabs·TheClanKimera·KimeraBase/KimeraBaseV-0.2/Kimera.kicad_pcb
About the Kimera PCB
Kimera is an open source ESP32 PCB design by TheClanLabs, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 114.3 × 30.5 mm, with 2 components from 2 distinct parts.
Its main chip is the ESP32-DEVKITC, from the ESP32 family. Other key parts include the E22-900M30S.
It belongs with the iot & wireless, rf & radio and power & battery designs in this gallery.
From the project
Kiera proyect common repository
The goal of this project is to create a device that facilitates the installation of powerful, stationary meshtastic nodes.
The following starting parameters are established:
The firmware that best fits the stated objective is the one developed by the Hydra project (https://github.com/Hydra-Designs/project-hydra-meshtastic-pcb) and is the one we are planning to use.

Main components on the Kimera
Kimera bill of materials (BOM)
2 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-DEVKITC | MODULE_ESP32-DEVKITC | U1 |
| 1 | E22-900M30S | XCVR_E22-900M30S | U2 |
Kimera design files
The KiCad project lives in the TheClanLabs/TheClanKimera repository on GitHub; these links point at the commit this page was built from.
Kimera: common questions
What microcontroller does the Kimera use?
The Kimera is built around the ESP32-DEVKITC, from the ESP32 family.
How big is the Kimera PCB?
The Kimera measures 114.3 × 30.5 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Kimera?
2 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the Kimera design files?
From the TheClanLabs/TheClanKimera repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Kimera design in my own project?
Yes, under the terms of its GPL-3.0 license, which TheClanLabs chose for the repository.
Can I test firmware for the Kimera without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8k