16 open source boards using the E22-900M30S

Real designs built with the E22-900M30S, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

16 boardsClear filters|Most starred

How designs wire the E22-900M30S

Read from the KiCad layouts of 14 open source designs, one per repository: what each pin of the E22-900M30S connects to, and the resistors, capacitors and other passives placed on it.

  • The DIO2 pin is left unconnected on 10 of 14 designs (a signal on 4).
GNDpin 1, 2, 3, 4, 5, 11, 12, 20, 22Connected to: GND 98%
DIO2pin 8Connected to: Not connected 71% · a signal 29%
VCCpin 9, 10Connected to: 5V 86%
  • Decoupling capacitor on 36% · 100 nF (8), 47 µF (4), 22 µF (2)

10 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Meshtastic DIY 1W board by Hydra-Designs, Ikoka nano meshtastic device by ndoo, MeshtasticStick by Oliver0804 and Mesh hand by sneakylizard123-4.

The E22-900M30S in open source designs

The gallery holds 16 open source boards using the E22-900M30S from 14 GitHub repositories; a typical one measures about 65 × 61 mm and carries around 42 components.

63% are two-layer designs, the rest use four layers or more, and 19% carry an open source license.

The most starred is Meshtastic DIY 1W board by Hydra-Designs.

Parts used alongside the E22-900M30S

Microcontrollers on boards using the E22-900M30S

E22-900M30S: common questions

Where can I find a E22-900M30S reference design?

Each of the 16 boards on this page is a real design using the E22-900M30S. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the E22-900M30S DIO2 pin connected?

The DIO2 pin is left unconnected on 10 of 14 designs (a signal on 4). Counted from the KiCad layouts of 14 open source designs using the E22-900M30S.

What parts are used alongside the E22-900M30S?

The ESP32-S3-WROOM-1, ESP32-DEVKITC and NEO-M8N appear in the most repositories here.

Which microcontrollers do boards using the E22-900M30S use?

Most are built on ESP32 (8), Nordic nRF (2), RP2040/RP2350 (2) and STM32 (1).

How big is a typical board using the E22-900M30S?

The median is 65 × 61 mm, and 63% are two-layer designs.

What is the most popular open source board using the E22-900M30S?

By GitHub stars, Meshtastic DIY 1W board by Hydra-Designs, with 166 stars.

Can I simulate one of these boards using the E22-900M30S before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part