Pico breakout

wesfletch·rookie·hw/pico_breakout/pico_breakout.kicad_pcb

Pico breakout layout, top view — open source RP2040/RP2350 board by wesfletch

About the Pico breakout

Pico breakout is an open source RP2040/RP2350 PCB design by wesfletch, published on GitHub. It is a 2-layer board measuring 66.5 × 63 mm, with 17 components from 14 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. Other key parts include the LSM6DSV16BTR and 74LVC14APW. By type, the board carries 8 connectors, 3 capacitors, 2 ICs, 2 test points, 1 module and 1 resistor.

It belongs with the robotics & motion and dev boards & breakouts designs in this gallery.

From the project

A small diff-drive robot, from scratch.

A differential-drive robot. The SBC runs ROS; an RPi Pico handles motor control and low-level I/O.

All subsequent build steps run inside the container. The src/ directory is mounted at ~/workspace/.

- src/picointerface — shared interface/messaging library (build first) - src/rookiepico — Pico firmware - src/ros — ROS workspace

Main components on the Pico breakout

LSM6DSV16BTR74LVC14APWRaspberryPi_Pico

Pico breakout bill of materials (BOM)

17 components, 14 distinct parts.

QtyPartRefs
1
LSM6DSV16BTR
U1
1
74LVC14APW
U2
1
RaspberryPi_Pico
A2
1
ENC1
J1
1
ENC2
J2
1
MTR
J3
1
DBG
J4
1
BREAKOUT
J5
1
SPI_DBG
J6
1
ENC_DBG
J7
1
MTR_DBG
J8
2
GND
TP4, TP22
3
100nF
C1, C2, C3
1
10k
R1

Pico breakout design files

The KiCad project lives in the wesfletch/rookie repository on GitHub; these links point at the commit this page was built from.

Pico breakout: common questions

What microcontroller does the Pico breakout use?

The Pico breakout is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the Pico breakout?

The Pico breakout measures 66.5 × 63 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pico breakout?

17 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pico breakout design files?

From the wesfletch/rookie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pico breakout design in my own project?

The repository has no license, so all rights stay with wesfletch. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Pico breakout without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

More boards in rookie

Similar boards