Hw openmower utils satabob

xtech·hw-openmower-utils·hw-openmower-utils-satabob/hw-openmower-utils-satabob.kicad_pcb

Hw openmower utils satabob PCB layout, top view — open source RP2040/RP2350 board by xtech

About the Hw openmower utils satabob PCB

Hw openmower utils satabob is an open source RP2040/RP2350 PCB design by xtech, published on GitHub. It is a 2-layer board measuring 40.9 × 66.5 mm, with 4 components from 3 distinct parts.

Its main chip is the Pico, from the RP2040/RP2350 family. By type, the board carries 3 connectors and 1 IC.

It belongs with the dev boards & breakouts designs in this gallery.

Hw openmower utils satabob, from the project README
From the project README

Main components on the Hw openmower utils satabob

Hw openmower utils satabob bill of materials (BOM)

4 components, 3 distinct parts.

QtyPartRefs
1
Pico
U1
1
67800-8005
J1
2
Conn_01x20_Pin
J2, J3

Hw openmower utils satabob design files

The KiCad project lives in the xtech/hw-openmower-utils repository on GitHub; these links point at the commit this page was built from.

Hw openmower utils satabob: common questions

What microcontroller does the Hw openmower utils satabob use?

The Hw openmower utils satabob is built around the Pico, from the RP2040/RP2350 family.

How big is the Hw openmower utils satabob PCB?

The Hw openmower utils satabob measures 40.9 × 66.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Hw openmower utils satabob?

4 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the Hw openmower utils satabob design files?

From the xtech/hw-openmower-utils repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Hw openmower utils satabob design in my own project?

The repository has no license, so all rights stay with xtech. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Hw openmower utils satabob without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

More boards in hw-openmower-utils

Similar boards