Swig after suite

AJC938·AI-PCB-Engineer·reports/v0.0.3/evidence/kicad/swig_after_suite.kicad_pcb

Swig after suite PCB layout, top view — open source board by AJC938

About the Swig after suite PCB

Swig after suite is an open source PCB design by AJC938, published on GitHub under the MIT license. It is a 2-layer board measuring 50 × 30 mm, with 4 components from 4 distinct parts.

By type, the board carries 2 resistors, 1 connector and 1 diode.

It belongs with the sensors designs in this gallery.

From the project

Sensor Interface & Power Management Board for ESP32

An open-source electronics project delivering a protected sensor interface and peripheral power board for an external ESP32 DevKit.

The board organizes power and signal connections between an ESP32 DevKit and compatible peripherals. It provides protected 5 V distribution, a regulated 3.3 V peripheral rail, conditioned sensor signals, and I²C, UART, and GPIO headers. The ESP32 is a separate development board and is powered through its own USB connection.

Swig after suite, from the project README
From the project README

Swig after suite bill of materials (BOM)

4 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
1715721
5V_IN
Phoenix Contact
J1
1
WP7113ID
Red
Kingbright
D1
1
MFR-25FBF52-620R
620
Yageo
R1
1
ERJ-3EKF1501V
1k
Panasonic
R2

Swig after suite design files

The KiCad project lives in the AJC938/AI-PCB-Engineer repository on GitHub; these links point at the commit this page was built from.

Swig after suite: common questions

How big is the Swig after suite PCB?

The Swig after suite measures 50 × 30 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Swig after suite?

4 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Swig after suite design files?

From the AJC938/AI-PCB-Engineer repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Swig after suite design in my own project?

Yes, under the terms of its MIT license, which AJC938 chose for the repository.

More boards in AI-PCB-Engineer

Similar boards