HardLabs

START MODULE

bismarx-v1·Sumec-MiniSumo-HW·main_hw/START_MODULE/START_MODULE.kicad_pcb

START MODULE layout, top view — open source AVR/Arduino board by bismarx-v1
Simulate this board

About the START MODULE

START MODULE is an open source AVR/Arduino PCB design by bismarx-v1, published on GitHub. It is a 2-layer board measuring 18.5 × 13 mm, with 12 components from 10 distinct parts.

Its main chip is the ATTINY85-20S, from the AVR/Arduino family. Other key parts include the TSOP382XX. By type, the board carries 3 resistors, 2 ICs, 2 connectors, 2 diodes, 2 capacitors and 1 switch.

It belongs with the robotics & motion designs in this gallery.

From the project

SUMEC is a MiniSumo robot designed by SPŠ na Proseku students. This repository contains hardware source for this project - PCB files and other electronics.

SUMEC - is an autonomous MiniSumo robot, that is designed to compete in MiniSumo competitions. MiniSumo robots are small 100mmx100mm autonomous robots that combine electronics, software and mechanics into one project, their task it to push their opponent out of a ring. This project is led and managed by SPŠ na Proseku students.

Project Contributors: - Antonín Havlík - Head Software Developer - Šimon Šťastný - Head Mechanical Designer and Developer - Jonáš Jarý - Mechanical Developer, Software and Hardware Development Assistant - Lukáš Houdek - Mechanical Designer and Developer, 3D Printing…

Main components on the START MODULE

ATTINY85-20STSOP382XX

START MODULE bill of materials (BOM)

12 components, 10 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATTINY85-20S
ATtiny85-20S
U1
1
TSOP382XX
TSOP382xx
U2
1
CONN_01X03_PIN
Conn_01x03_Pin
J1
1
CONN_01X04_PIN
Conn_01x04_Pin
J2
1
SW_Push
SW1
2
LED
D1, D2
1
10UF
10uF
C1
1
100NF
100nF
C2
2
220R
R1, R3
1
10K
10k
R2

START MODULE design files

The KiCad project lives in the bismarx-v1/Sumec-MiniSumo-HW repository on GitHub; these links point at the commit this page was built from.

START MODULE: common questions

What microcontroller does the START MODULE use?

The START MODULE is built around the ATTINY85-20S, from the AVR/Arduino family.

How big is the START MODULE?

The START MODULE measures 18.5 × 13 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the START MODULE?

12 components, from 10 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the START MODULE design files?

From the bismarx-v1/Sumec-MiniSumo-HW repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the START MODULE design in my own project?

The repository has no license, so all rights stay with bismarx-v1. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the START MODULE without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Sumec-MiniSumo-HW

Similar boards