RobotSchematic

cobalt-s·CRAB·RobotSchematicKICAD/RobotSchematicPCB/RobotSchematicPCB.kicad_pcb

RobotSchematic PCB layout, top view — open source ESP32 board by cobalt-s

About the RobotSchematic PCB

RobotSchematic is an open source ESP32 PCB design by cobalt-s, published on GitHub under the MIT license. It is a 2-layer board measuring 226.1 × 226.1 mm, with 40 components from 12 distinct parts.

Its main chip is the ESP32-WROOM-32E, from the ESP32 family. Other key parts include the PCA9685PW and 74HC595. By type, the board carries 8 diodes, 3 ICs, 2 capacitors and 1 resistor.

It belongs with the robotics & motion designs in this gallery.

From the project

A quad pod robot.

Main components on the RobotSchematic

RobotSchematic bill of materials (BOM)

40 components, 12 distinct parts.

QtyPartRefs
1
PCA9685PW
U1
1
ESP32-WROOM-32E
U2
1
74HC595
U3
2
10k
BOOTPULL1, ENPULL1
1
AMS1117-3.3
LDO1
8
330
LEDR1, LEDR2, LEDR3, LEDR4, LEDR5, LEDR6, LEDR7, LEDR8
12
Conn_01x03_Pin
SERVO1, SERVO2, SERVO3, SERVO4, SERVO5, SERVO6, SERVO7, SERVO8 +4
2
SW_Push
SWBOOT1, SWEN1
1
Screw_Terminal_01x02
XT90BATTERY1
8
LED
D1, D2, D3, D4, D5, D6, D7, D8
2
10u
C1, C2
1
10k
R1

RobotSchematic design files

The KiCad project lives in the cobalt-s/CRAB repository on GitHub; these links point at the commit this page was built from.

RobotSchematic: common questions

What microcontroller does the RobotSchematic use?

The RobotSchematic is built around the ESP32-WROOM-32E, from the ESP32 family.

How big is the RobotSchematic PCB?

The RobotSchematic measures 226.1 × 226.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the RobotSchematic?

40 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the RobotSchematic design files?

From the cobalt-s/CRAB repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the RobotSchematic design in my own project?

Yes, under the terms of its MIT license, which cobalt-s chose for the repository.

Can I test firmware for the RobotSchematic without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in CRAB

Similar boards