Flash sop rev4

DangerousPrototypes·BusPirate5-hardware·development/adapter-flash-sop-1REV4/flash-sop-rev4.kicad_pcb

Flash sop rev4 PCB layout, top view — open source board by DangerousPrototypes

About the Flash sop rev4 PCB

Flash sop rev4 is an open source PCB design by DangerousPrototypes, published on GitHub under the MIT license. It is a 2-layer board measuring 42.8 × 42 mm, with 7 components from 6 distinct parts.

By type, the board carries 3 connectors, 2 switches, 1 diode and 1 resistor.

It belongs with the displays & leds, power & battery and test & measurement designs in this gallery, and the repository also holds 1 earlier revision of it.

From the project

Bus Pirate Hardware and accessories for v5 and higher

Bus Pirate 5 is the latest edition of the universal serial interface trusted by hackers since 2008.

Can't get a chip to work? Is it the circuit, code, bad part or a burned out pin? The Bus Pirate sends commands over common serial protocols (1-Wire, I2C, SPI, UART, MIDI, serial LEDs, etc) so you can get to know a chip before prototyping. Updated with tons of new features, talking to chips and probing interfaces is more fun than ever!

Flash sop rev4, from the project README
From the project README

Flash sop rev4 bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
CONN_01X10
Conn_01x10
J1
1
16PIN
J3
1
20PIN
J5
2
SW_SPDT
SW1, SW2
1
LED
D1
1
2K
R1

Flash sop rev4 design files

The KiCad project lives in the DangerousPrototypes/BusPirate5-hardware repository on GitHub; these links point at the commit this page was built from.

Flash sop rev4: common questions

How big is the Flash sop rev4 PCB?

The Flash sop rev4 measures 42.8 × 42 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Flash sop rev4?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Flash sop rev4 design files?

From the DangerousPrototypes/BusPirate5-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Flash sop rev4 design in my own project?

Yes, under the terms of its MIT license, which DangerousPrototypes chose for the repository.

More boards in BusPirate5-hardware

Earlier revisions in the repo: flash-sop-rev3

Similar boards