Stemma qwiic grove gravity bog plank-1REV1

DangerousPrototypes·BusPirate5-hardware·adapter-stemma-qwiic-grove-gravity-bog-plank-1REV1/stemma-qwiic-grove-gravity-bog-plank-1REV1.kicad_pcb

Stemma qwiic grove gravity bog plank-1REV1 PCB layout, top view — open source board by DangerousPrototypes

About the Stemma qwiic grove gravity bog plank-1REV1 PCB

Stemma qwiic grove gravity bog plank-1REV1 is an open source PCB design by DangerousPrototypes, published on GitHub under the MIT license. It is a 2-layer board measuring 39.5 × 51 mm, with 12 components from 8 distinct parts.

By type, the board carries 10 connectors, 1 diode and 1 resistor.

It belongs with the displays & leds, power & battery and test & measurement designs in this gallery.

From the project

Bus Pirate Hardware and accessories for v5 and higher

Bus Pirate 5 is the latest edition of the universal serial interface trusted by hackers since 2008.

Can't get a chip to work? Is it the circuit, code, bad part or a burned out pin? The Bus Pirate sends commands over common serial protocols (1-Wire, I2C, SPI, UART, MIDI, serial LEDs, etc) so you can get to know a chip before prototyping. Updated with tons of new features, talking to chips and probing interfaces is more fun than ever!

Stemma qwiic grove gravity bog plank-1REV1, from the project README
From the project README

Stemma qwiic grove gravity bog plank-1REV1 bill of materials (BOM)

12 components, 8 distinct parts — part numbers from the project's BOM.

QtyPartRefs
4
SM04B-SRSS-TB (HC-1.0-4PWT)
J1, J2, J3, J4
2
S4B-PH-SM4-TB (HC-PH-4AWT)
J6, J8
1
S3B-PH-SM4-TB (HC-PH-3AWT)
J7
1
HY-4P
J9
1
ED10BGFBK
J10
1
CONN_01X10
Conn_01x10
J12
1
LED
D1
1
2K
R1

Stemma qwiic grove gravity bog plank-1REV1 design files

The KiCad project lives in the DangerousPrototypes/BusPirate5-hardware repository on GitHub; these links point at the commit this page was built from.

Stemma qwiic grove gravity bog plank-1REV1: common questions

How big is the Stemma qwiic grove gravity bog plank-1REV1 PCB?

The Stemma qwiic grove gravity bog plank-1REV1 measures 39.5 × 51 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Stemma qwiic grove gravity bog plank-1REV1?

12 components, from 8 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Stemma qwiic grove gravity bog plank-1REV1 design files?

From the DangerousPrototypes/BusPirate5-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Stemma qwiic grove gravity bog plank-1REV1 design in my own project?

Yes, under the terms of its MIT license, which DangerousPrototypes chose for the repository.

More boards in BusPirate5-hardware

Similar boards