Starbie

den4ik9591·starbie-pcb·HalfLife10weeks/Hardware/Starbie/Test.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by den4ik9591

About the Starbie PCB

Starbie is an open source ESP32 PCB design by den4ik9591, published on GitHub. It is a 2-layer board measuring 120 × 111.5 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

My starbie project

A tiny star-shaped desk pet. A XIAO ESP32-C3 draws a wandering pet on a 0.96" OLED screen. You can open a radial menu with a button, tilt the board to pick an action, and check the room temperature and humidity on a stats screen.

I made this for Half Life Week 1, following the Starbie guide, and then changed it to make it my own.

- Star-shaped board: I drew my own star outline on the Edge.Cuts layer in KiCad, so the PCB itself is a star. - New menu action: I replaced PET with DANCE, a more energetic move with its own joy/energy/fullness values. - Sparkle trail: I added a drawSparkle…

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Starbie design files

The KiCad project lives in the den4ik9591/starbie-pcb repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 120 × 111.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the den4ik9591/starbie-pcb repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with den4ik9591. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards