Cloneduino zero

eepj·cloneduino-zero·Hardware/cloneduino_zero.kicad_pcb

Cloneduino zero PCB layout, top view — open source Microchip SAM board by eepj

About the Cloneduino zero PCB

Cloneduino zero is an open source Microchip SAM PCB design by eepj, published on GitHub. It is a 4-layer board measuring 50 × 19.7 mm, with 28 components from 18 distinct parts.

Its main chip is the ATSAMD21G18A-A, from the Microchip SAM family. Other key parts include the SPX3819M5-L-3-3. By type, the board carries 11 capacitors, 5 connectors, 5 resistors, 2 ICs, 2 diodes and 1 crystal.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

An Arduino Zero clone in a breadboard-compatible form factor.

Main components on the Cloneduino zero

Cloneduino zero bill of materials (BOM)

28 components, 18 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
SPX3819M5-L-3-3
U1
1
ATSAMD21G18A-A
U2
1
32.768KHZ
32kHz
Y1
1
USB-C Receptacle
J1
1
MicroSD Slot
J2
2
CONN_01X20
Conn_01x20
J3, J4
1
SWD
J5
1
Reset Switch
SW1
1
D13
D1
1
PWR
D2
1
L
L1
7
100N
100n
C1, C2, C3, C4, C5, C7, C9
1
4.7U
2.2u
C6
1
4.7U
4.7u
C8
2
15P
15p
C10, C11
2
5K1
4k7
R1, R2
2
5K1
5k1
R3, R4
1
5K1
10k
R5

Cloneduino zero design files

The KiCad project lives in the eepj/cloneduino-zero repository on GitHub; these links point at the commit this page was built from.

Cloneduino zero: common questions

What microcontroller does the Cloneduino zero use?

The Cloneduino zero is built around the ATSAMD21G18A-A, from the Microchip SAM family.

How big is the Cloneduino zero PCB?

The Cloneduino zero measures 50 × 19.7 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Cloneduino zero?

28 components, from 18 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Cloneduino zero design files?

From the eepj/cloneduino-zero repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Cloneduino zero design in my own project?

The repository has no license, so all rights stay with eepj. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Cloneduino zero without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Microchip SAM firmware against it before you order a PCB.

Similar boards