Starbie

ema-rauf·starbie·Starbie/Starbie.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by ema-rauf

About the Starbie PCB

Starbie is an open source ESP32 PCB design by ema-rauf, published on GitHub. It is a 2-layer board measuring 80 × 70 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the iot & wireless, displays & leds and sensors designs in this gallery.

From the project

A small motion-controlled desk pet on a custom PCB. A XIAO ESP32-C3 draws a wandering pet on a 0.96" OLED, an MPU6050 reads tilt and shakes, a DHT11 reads temperature and humidity, and two buttons open a radial menu and a stats screen.

A small motion-controlled desk pet on a custom PCB. A XIAO ESP32-C3 draws a wandering pet on a 0.96" OLED, an MPU6050 reads tilt and shakes, a DHT11 reads temperature and humidity, and two buttons open a radial menu and a stats screen.

Built for Hack Club Half-Life, Week 1 (PCB design). Based on the Week 1 example project by SharKingStudios.

The OLED and the MPU6050 share the same two I2C lines. The ground net is a copper pour on both layers.

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW3
1
10K
R1

Starbie design files

The KiCad project lives in the ema-rauf/starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 80 × 70 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the ema-rauf/starbie repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with ema-rauf. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards