HardLabs

Boiler BASE

energietransitie·needforheat-boiler-monitor-hardware·pcb/BoilerBASE/BoilerBASE.kicad_pcb

Boiler BASE PCB layout, top view — open source board by energietransitie

About the Boiler BASE PCB

Boiler BASE is an open source PCB design by energietransitie, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 51.6 × 36 mm, with 6 components from 5 distinct parts.

By type, the board carries 4 connectors and 2 resistors.

It belongs with the sensors designs in this gallery.

From the project

Open hardware design files for the NeedForHeat Boiler Monitor devices

This repository contains the open hardware design files for the NeedForHeat Boiler Monitor hardware, which consists of PCB and 3D printable pipeclamps for:

Boiler-BASE module for the on the back of an M5Stack CoreInk device; Thermostat Cable Splitter module, which is inserted by the subject in the signal path between boiler and thermostat; * Two pipe clamps with temperature sensors that can be clipped on the supply and return pipes that carry hot water from the boiler to the radiators and returning from the radiators.

Boiler BASE, from the project README
From the project README

Boiler BASE bill of materials (BOM)

6 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TEMP-1
Temp-1
J1
1
TEMP-2
Temp-2
J2
1
OpenThermMonitor
J3
1
M5STACK-MI-BUS
M5stack-MI-bus
J5
2
4K7
4k7
R1, R2

Boiler BASE design files

The KiCad project lives in the energietransitie/needforheat-boiler-monitor-hardware repository on GitHub; these links point at the commit this page was built from.

Boiler BASE: common questions

How big is the Boiler BASE PCB?

The Boiler BASE measures 51.6 × 36 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Boiler BASE?

6 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Boiler BASE design files?

From the energietransitie/needforheat-boiler-monitor-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Boiler BASE design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which energietransitie chose for the repository.

More boards in needforheat-boiler-monitor-hardware

Similar boards