HardLabs

NFH PipeSensors

energietransitie·needforheat-boiler-monitor-hardware·pcb/PipeClamp/PipeClamp.kicad_pcb

NFH PipeSensors PCB layout, top view — open source board by energietransitie

About the NFH PipeSensors PCB

NFH PipeSensors is an open source PCB design by energietransitie, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 40 × 15 mm, with 3 components from 3 distinct parts.

Other key parts include the DS18B20Z. By type, the board carries 1 IC, 1 connector and 1 capacitor.

It belongs with the sensors designs in this gallery.

From the project

Open hardware design files for the NeedForHeat Boiler Monitor devices

This repository contains the open hardware design files for the NeedForHeat Boiler Monitor hardware, which consists of PCB and 3D printable pipeclamps for:

Boiler-BASE module for the on the back of an M5Stack CoreInk device; Thermostat Cable Splitter module, which is inserted by the subject in the signal path between boiler and thermostat; * Two pipe clamps with temperature sensors that can be clipped on the supply and return pipes that carry hot water from the boiler to the radiators and returning from the radiators.

NFH PipeSensors, from the project README
From the project README

Main components on the NFH PipeSensors

DS18B20Z

NFH PipeSensors bill of materials (BOM)

3 components, 3 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
DS18B20Z
U1
1
RJ12
J1
1
100NF
100nF
C1

NFH PipeSensors design files

The KiCad project lives in the energietransitie/needforheat-boiler-monitor-hardware repository on GitHub; these links point at the commit this page was built from.

NFH PipeSensors: common questions

How big is the NFH PipeSensors PCB?

The NFH PipeSensors measures 40 × 15 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the NFH PipeSensors?

3 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the NFH PipeSensors design files?

From the energietransitie/needforheat-boiler-monitor-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the NFH PipeSensors design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which energietransitie chose for the repository.

More boards in needforheat-boiler-monitor-hardware

Similar boards