Starbie

hannahhhhhhhhhhhhhhh·Starbie·kicad/starbie.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by hannahhhhhhhhhhhhhhh

About the Starbie PCB

Starbie is an open source ESP32 PCB design by hannahhhhhhhhhhhhhhh, published on GitHub. It is a 2-layer board measuring 149 × 94 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

Microcontroller: 1x Seeed Studio XIAO-ESP32-C3 Sensors: 1x DHT11 Environment Sensor (Temperature & Humidity) 1x MPU6050 6-Axis Motion Tracking Module (Accelerometer & Gyroscope) Display: 1x I2C OLED Display Module (4-pin setup: VCC, GND, SCL, SDA) Discreet Components: 2x 6x6mm Ta

Microcontroller: 1x Seeed Studio XIAO-ESP32-C3 Sensors: 1x DHT11 Environment Sensor (Temperature & Humidity) 1x MPU6050 6-Axis Motion Tracking Module (Accelerometer & Gyroscope) Display: 1x I2C OLED Display Module (4-pin setup: VCC, GND, SCL, SDA) Discreet Components: 2x 6x6mm Tactile Push Buttons (SWPush) * 1x 10kΩ Axial Resistor (Pull-up for DHT11 data line)

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Starbie design files

The KiCad project lives in the hannahhhhhhhhhhhhhhh/Starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 149 × 94 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the hannahhhhhhhhhhhhhhh/Starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with hannahhhhhhhhhhhhhhh. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards