LEAFIE-PCB-Pet

IbrahimYounes890·LEAFIE-PCB-Pet·PCB/LEAFIE.kicad_sch

LEAFIE-PCB-Pet

About the LEAFIE-PCB-Pet

LEAFIE-PCB-Pet is an open source ESP32 PCB design by IbrahimYounes890, published on GitHub. It is a board, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

This is my first half life project!

This is my Starbie-inspired PCB pet project --> LEAFIE!

LEAFIE is a tiny motion-controlled digital pet, created using Starbie's guide on GitHub. He too is also a pet that is controlled by motion rather than using controls.

It is a pet that sits on your desk, displays personality and character on the display, and can be interacted with via two buttons and a motion sensor. It includes a microcontroller, display, motion sensor, and environmental sensor in a custom-designed PCB in the shape of a Canadian maple leaf.

Main components on the LEAFIE-PCB-Pet

LEAFIE-PCB-Pet bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

LEAFIE-PCB-Pet design files

The KiCad project lives in the IbrahimYounes890/LEAFIE-PCB-Pet repository on GitHub; these links point at the commit this page was built from.

LEAFIE-PCB-Pet: common questions

What microcontroller does the LEAFIE-PCB-Pet use?

The LEAFIE-PCB-Pet is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How many components are on the LEAFIE-PCB-Pet?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the LEAFIE-PCB-Pet design files?

From the IbrahimYounes890/LEAFIE-PCB-Pet repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the LEAFIE-PCB-Pet design in my own project?

The repository has no license, so all rights stay with IbrahimYounes890. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the LEAFIE-PCB-Pet without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards