HardLabs

Touchuc

jonnor·projects·jewelry/touchuc/touchuc.kicad_pcb

Touchuc PCB layout, top view — open source AVR/Arduino board by jonnor
Simulate this board

About the Touchuc PCB

Touchuc is an open source AVR/Arduino PCB design by jonnor, published on GitHub. It is a 2-layer board measuring 13 × 13 mm, with 16 components from 8 distinct parts.

Its main chip is the ATTINY10-TS, from the AVR/Arduino family. By type, the board carries 9 connectors, 2 diodes, 2 resistors, 1 IC and 1 capacitor.

It belongs with the robotics & motion and power & battery designs in this gallery.

From the project

Small projects not worthy of dedicated repositories

Etsy.com. Lots of amazing looking products. Mostly rings,pendants. Pure resin or resin+wood. 200-400 NOK. Sometimes glow-in-the-dark. Resin 'stone' with wood base, silver ring inlay. 700-800 NOK.

Maybe silver + resin cast rings has good opportunity? Not found, might be able to push price up.

Oxididation. Electroetching with laser-engraved masks?

Power board for wearable or other battery powered electronics.

Main components on the Touchuc

ATTINY10-TS

Touchuc bill of materials (BOM)

16 components, 8 distinct parts.

QtyPartRefs
1
ATTINY10-TS
U1
2
Conn_01x01
J1, J2
1
Conn_01x01
J3
6
Conn_01x01
J4, J5, J6, J7, J8, J9
1
R
1k1
2
LED
D1, D2
1
C
C1
2
R
R1, R2

Touchuc design files

The KiCad project lives in the jonnor/projects repository on GitHub; these links point at the commit this page was built from.

Touchuc: common questions

What microcontroller does the Touchuc use?

The Touchuc is built around the ATTINY10-TS, from the AVR/Arduino family.

How big is the Touchuc PCB?

The Touchuc measures 13 × 13 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Touchuc?

16 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Touchuc design files?

From the jonnor/projects repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Touchuc design in my own project?

The repository has no license, so all rights stay with jonnor. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Touchuc without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in projects

Similar boards