Opt101 receiver

nguyenhuy0426·PPG_simulator·hardware/opt101_receiver_kicad/opt101_receiver/opt101_receiver.kicad_pcb

Opt101 receiver PCB layout, top view — open source board by nguyenhuy0426

About the Opt101 receiver PCB

Opt101 receiver is an open source PCB design by nguyenhuy0426, published on GitHub under the MIT license. It is a 2-layer board measuring 70 × 20 mm, with 11 components from 7 distinct parts.

Other key parts include the OPT101P. By type, the board carries 4 capacitors, 3 connectors, 2 ICs and 2 resistors.

It belongs with the audio and test & measurement designs in this gallery.

From the project

The PPG Signal Simulator is a portable device that generates synthetic PPG (photoplethysmography) waveforms with physiologically accurate morphology. It outputs the signal via a 12‑bit DAC for connection to patient monitors, oscilloscopes, or data acquisition systems.

Mở opt101receiver.kicadpro bằng KiCad 10, rồi mở schematic hoặc PCB. Thiết kế đã đi dây hai lớp, có thư viện symbol, footprint và mô hình 3D cục bộ. Ảnh reports/pcbtop.png hiển thị socket trống, chưa cắm IC OPT101P. Mặt sau có silkscreen DATN: PPG-Simulator và Nguyen Nhat Huy - Pham Thanh Vy; xem reports/pcbbottom.png. Mặt sau cũng ghi tên tín hiệu tại từng pad J1/J2/J3 và từng hàng chân của hai socket OPT101. Các nhãn này không dùng số thứ tự chân; R/I là hai đầu ra, V là 3,3 V, GR/GI là ground theo kênh, FB là hồi tiếp và NC` để hở.

Main components on the Opt101 receiver

Opt101 receiver bill of materials (BOM)

11 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
OPT101P
U1, U2
1
A2 / RED
J1
1
A0 / IR
J2
1
ADS1115 outputs
J3
2
100nF 50V X7R ceramic
C1, C2
2
1uF X7R 16V
C3, C4
2
1k 1%
R1, R2

Opt101 receiver design files

The KiCad project lives in the nguyenhuy0426/PPG_simulator repository on GitHub; these links point at the commit this page was built from.

Opt101 receiver: common questions

How big is the Opt101 receiver PCB?

The Opt101 receiver measures 70 × 20 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Opt101 receiver?

11 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Opt101 receiver design files?

From the nguyenhuy0426/PPG_simulator repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Opt101 receiver design in my own project?

Yes, under the terms of its MIT license, which nguyenhuy0426 chose for the repository.

More boards in PPG_simulator

Similar boards