HardLabs

Sensor and Display Module

Paa-Kwasi-04·Kicad_Projects·Sensor and Display Module/Sensor and Display Module.kicad_pcb

Sensor and Display Module layout, top view — open source AVR/Arduino board by Paa-Kwasi-04

About the Sensor and Display Module

Sensor and Display Module is an open source AVR/Arduino PCB design by Paa-Kwasi-04, published on GitHub. It is a 2-layer board measuring 64.3 × 88.9 mm, with 21 components from 12 distinct parts.

Its main chip is the ATmega328-P, from the AVR/Arduino family. By type, the board carries 2 capacitors and 1 IC.

It belongs with the displays & leds and sensors designs in this gallery.

Main components on the Sensor and Display Module

ATmega328-P

Sensor and Display Module bill of materials (BOM)

21 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATmega328-P
U1
1
10n
Caref1
2
0.1u
Cavcc1, Creset1
1
AVR-ISP-6
ISP1
7
SM04B-SRSS-TB
Jst1, Jst2, Jst3, Jst4, Jst5, Jst6, Jst7
1
EA_T123X-I2C
LCD1
1
TCA9548APWR
MUX1
1
Pot
RV1
2
10k
Rresetmcu1, Rresetmux1
2
4.7k
Rscl1, Rsda1
1
0.5UF
22p
C1
1
470UF
22p
C2

Sensor and Display Module design files

The KiCad project lives in the Paa-Kwasi-04/Kicad_Projects repository on GitHub; these links point at the commit this page was built from.

Sensor and Display Module: common questions

What microcontroller does the Sensor and Display Module use?

The Sensor and Display Module is built around the ATmega328-P, from the AVR/Arduino family.

How big is the Sensor and Display Module?

The Sensor and Display Module measures 64.3 × 88.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Sensor and Display Module?

21 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Sensor and Display Module design files?

From the Paa-Kwasi-04/Kicad_Projects repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Sensor and Display Module design in my own project?

The repository has no license, so all rights stay with Paa-Kwasi-04. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Sensor and Display Module without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Kicad_Projects

Similar boards