HardLabs

GOPHER

SaltyMelonYT·PCB-Projects·AI-board/GOPHER/GOPHER.kicad_pcb

GOPHER PCB layout, top view — open source Raspberry Pi board by SaltyMelonYT

About the GOPHER PCB

GOPHER is an open source Raspberry Pi PCB design by SaltyMelonYT, published on GitHub under the MIT license. It is a 2-layer board measuring 62 × 49.2 mm, with 4 components from 4 distinct parts.

Its main chip is the ComputeModule5-CM5, from the Raspberry Pi family.

From the project

I'm a nerd

GOPHER bill of materials (BOM)

4 components, 4 distinct parts.

QtyPartRefs
1
Micro_SD_Card
J1
1
USB_C_Receptacle_PowerOnly_6P
J2
1
USB_B_Micro
J3
1
ComputeModule5-CM5
Module1

GOPHER design files

The KiCad project lives in the SaltyMelonYT/PCB-Projects repository on GitHub; these links point at the commit this page was built from.

GOPHER: common questions

What microcontroller does the GOPHER use?

The GOPHER is built around the ComputeModule5-CM5, from the Raspberry Pi family.

How big is the GOPHER PCB?

The GOPHER measures 62 × 49.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the GOPHER?

4 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the GOPHER design files?

From the SaltyMelonYT/PCB-Projects repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the GOPHER design in my own project?

Yes, under the terms of its MIT license, which SaltyMelonYT chose for the repository.

Can I test firmware for the GOPHER without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

More boards in PCB-Projects

Similar boards