Starbie

Senvor·Starbie·pcb/Starbie.kicad_pcb

Starbie PCB layout, top view — open source ESP32 board by Senvor

About the Starbie PCB

Starbie is an open source ESP32 PCB design by Senvor, published on GitHub. It is a 2-layer board measuring 105 × 87 mm, with 11 components from 8 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 4 resistors, 2 ICs, 2 connectors, 2 switches and 1 diode.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

A tiny motion-controlled digital pet, basically a desktop Tamagotchi. Totally not a Starboy.

A tiny motion-controlled digital pet, basically a desktop Tamagotchi. Totally not a Starboy.

Starbie is a small interactive device built around the XIAO ESP32-C3. It uses a bunch of sensors and other components to make it actually do stuff.

- Movement detection using the MPU6050. - Temperature and humidity readings using the DHT11. - An OLED display to show information. - An RGB LED for visual feedback. - Cherry MX switches for physical input.

Starbie, from the project README
From the project README

Main components on the Starbie

Starbie bill of materials (BOM)

11 components, 8 distinct parts.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
LED_RGB
D1
1
10k
R1
3
330
R2, R3, R4

Starbie design files

The KiCad project lives in the Senvor/Starbie repository on GitHub; these links point at the commit this page was built from.

Starbie: common questions

What microcontroller does the Starbie use?

The Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie PCB?

The Starbie measures 105 × 87 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie?

11 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Starbie design files?

From the Senvor/Starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Starbie design in my own project?

The repository has no license, so all rights stay with Senvor. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards