Starbie-Hackclub

shankarnoone-stack·Starbie-Hackclub

Starbie-Hackclub PCB layout, top view — open source ESP32 board by shankarnoone-stack

About the Starbie-Hackclub PCB

Starbie-Hackclub is an open source ESP32 PCB design by shankarnoone-stack, published on GitHub. It is a 2-layer board measuring 107.8 × 84.5 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the keyboards, displays & leds and sensors designs in this gallery.

From the project

I designed the schematic and PCB in KiCad, routed the traces, and exported the fabrication files. This is my Week 1 PCB project for Hack Club Half Life.

I designed the schematic and PCB in KiCad, routed the traces, and exported the fabrication files. This is my Week 1 PCB project for Hack Club Half Life.

Starbie is designed to sit on your desk, show its personality on a small display, and react to how you handle it. Tilting, moving, and otherwise checking in on your pet are meant to be part of the experience.

Main components on the Starbie-Hackclub

Starbie-Hackclub bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Starbie-Hackclub design files

The KiCad project lives in the shankarnoone-stack/Starbie-Hackclub repository on GitHub; these links point at the commit this page was built from.

Starbie-Hackclub: common questions

What microcontroller does the Starbie-Hackclub use?

The Starbie-Hackclub is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starbie-Hackclub PCB?

The Starbie-Hackclub measures 107.8 × 84.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starbie-Hackclub?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Starbie-Hackclub design files?

From the shankarnoone-stack/Starbie-Hackclub repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Starbie-Hackclub design in my own project?

The repository has no license, so all rights stay with shankarnoone-stack. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starbie-Hackclub without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards