ESP32-

shreejita56·ESP32-·PCB/ESP32 Devoard.kicad_pcb

ESP32- PCB layout, top view — open source ESP32 board by shreejita56

About the ESP32- PCB

ESP32- is an open source ESP32 PCB design by shreejita56, published on GitHub. It is a 2-layer board measuring 41.1 × 53.2 mm, with 23 components from 16 distinct parts.

Its main chip is the ESP32-S3-WROOM-1, from the ESP32 family. Other key parts include the AP63203WU. By type, the board carries 7 capacitors, 7 resistors, 3 connectors, 2 ICs, 2 switches and 1 diode.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

So I made a simple Dev-board based on ESP32-S3-WROOM-1 . It has a USB-C for Communication and has all possible pin available on the Rp2040 . Boot/EN Pins 3.3V Voltage regulator on board LEDS . I tried to make it in a concise design. It was designed On kicad.

ESP32-, from the project README
From the project README

Main components on the ESP32-

ESP32- bill of materials (BOM)

23 components, 16 distinct parts.

QtyPartRefs
1
AP63203WU
U2
1
ESP32-S3-WROOM-1
U3
1
USB_C_Receptacle_USB2.0_16P
J1
2
Conn_01x20_Pin
J2, J3
2
SW_Push
SW1, SW2
1
LED
D1
1
4.7uh
L1
1
47uf
C1
1
10uf
C2
1
100nf
C3
2
22uf
C4, C5
2
C
C6, C7
2
33
R1, R2
2
5.1 K
R3, R4
2
R
R5, R6
1
1K
R7

ESP32- design files

The KiCad project lives in the shreejita56/ESP32- repository on GitHub; these links point at the commit this page was built from.

ESP32-: common questions

What microcontroller does the ESP32- use?

The ESP32- is built around the ESP32-S3-WROOM-1, from the ESP32 family.

How big is the ESP32- PCB?

The ESP32- measures 41.1 × 53.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the ESP32-?

23 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the ESP32- design files?

From the shreejita56/ESP32- repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the ESP32- design in my own project?

The repository has no license, so all rights stay with shreejita56. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ESP32- without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards