Ninja-Sensor

suhaan2485·Ninja-Sensor·KiCad Files/StarBoard.kicad_pcb

Ninja-Sensor PCB layout, top view — open source ESP32 board by suhaan2485

About the Ninja-Sensor PCB

Ninja-Sensor is an open source ESP32 PCB design by suhaan2485, published on GitHub. It is a 2-layer board measuring 88.8 × 86 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the displays & leds and sensors designs in this gallery.

From the project

A Basic Motion Sensor Interface with buttons & an LCD Screen !

A Basic Motion Sensor Interface with buttons and an LCD Screen !

Ninja-Sensor, from the project README
From the project README

Main components on the Ninja-Sensor

Ninja-Sensor bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Ninja-Sensor design files

The KiCad project lives in the suhaan2485/Ninja-Sensor repository on GitHub; these links point at the commit this page was built from.

Ninja-Sensor: common questions

What microcontroller does the Ninja-Sensor use?

The Ninja-Sensor is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Ninja-Sensor PCB?

The Ninja-Sensor measures 88.8 × 86 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ninja-Sensor?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Ninja-Sensor design files?

From the suhaan2485/Ninja-Sensor repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Ninja-Sensor design in my own project?

The repository has no license, so all rights stay with suhaan2485. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Ninja-Sensor without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards